English
Español
Português
Русский
Deutsch
Francés
العربية
한국어
Türk
日本語
Industry News
An IGU production line can run smoothly during a supplier demonstration and still cause trouble after it arrives at your factory. The reason is usually not the brochure speed. It is whether the line can process your actual glass, materials, utilities and product range on a normal working day.
2026/09/28 15:16
A production line can have the right machines and still perform poorly if the factory layout is not planned carefully.A glass washer placed too far from the assembly area may create unnecessary handling. Spacer frames may have to cross the same aisle used for finished glass. Maintenance staff may
2026/09/24 13:43
On an insulating glass production line, the desiccant filler rarely receives as much attention as the washer, press or sealing robot. It is smaller, its working cycle looks straightforward, and it does not handle large panes of glass.That does not make it unimportant.If the spacer is not filled
2026/09/21 16:51
Before You Buy an Insulating Glass Production LineStart with last month’s production sheet, not the supplier’s brochure.That sheet tells you what really moves through the factory: the glass sizes ordered most often, the awkward jobs that slow everyone down and the number of times operators change
2026/09/20 16:20
What Should Operators Check When Changing Drums on a Two-Component Sealant Extruder?After changing an A-component or B-component drum, do not return the two-component sealant extruder directly to full production. Confirm the material identity and condition, install the container according to the
2026/09/18 10:51
Before accepting an IGU production line, run the machine with glass that represents your real orders—not only the supplier’s easiest demonstration pane. The test should cover washing and drying, size changes, assembly, pressing, every purchased optional function and an approved stop-and-restart
2026/09/16 10:04
Why Is Glass Dry in the Center but Still Wet at the Edges?If the center of a pane leaves the washer dry while the edges still carry water, do not immediately increase the heat or change several settings. First, record exactly where the moisture remains. A wet trailing edge, one consistently wet
2026/09/15 14:53
Molecular Sieve Filler Stops Early: What Should You Check First?When a molecular sieve filling machine stops before the spacer is full, do not immediately increase the filling time or change several settings. Save the first affected frame and record exactly where the cycle ended. Then check the
2026/09/14 14:16
IGU Production Line Utility Requirements: A Pre-Order ChecklistBefore ordering an IGU production line, send the supplier more than your maximum glass size and target output. A useful project file should cover the glass products you make, available floor space, electrical supply, compressed air,
2026/09/11 13:42
Butyl Bead Shifts After a Spacer Width Change: What to CheckWhen a butyl bead moves off-center immediately after changing spacer width, check the spacer’s physical position before changing the sealant temperature or pressure. The new width may be entered correctly on the screen while the spacer is
2026/09/10 09:15
How to Choose the Right Working Direction for an IGU Production LineThere is no universally better direction for an automatic IGU production line. A left-to-right line is correct when it follows the factory’s material flow; a right-to-left line is correct when the building, storage area and
2026/09/09 09:41
Online or Offline Argon Filling: Which Setup Fits Your IGU Production Line?Choose online argon filling when gas filling needs to remain inside a coordinated automatic assembly and pressing process. Consider offline filling when adding the function to an existing line, handling lower or irregular
2026/09/07 10:53
